View Single Post
Old March 22nd, 2011, 10:06 AM   #109
John D
Senior Member
John D's Avatar
Join Date: 02-01-08
Location: Rockford, MI
Posts: 574
iTrader: (6)
Mentioned: 1 Post(s)

I did the grease method and it worked very well. It was not messy, but then again I used the minimum amount of grease I thought would be effective.

I will look this weekend to see what I used (I still have the tap and drill bit), but 37/64" sounds familiar; probably was the 3/8" NPT.
John D is offline   Reply With Quote
Page generated in 0.03977 seconds with 11 queries