Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 1983 Scrambler build: 5.3 / TH350 swap
View Single Post
Old March 22nd, 2011, 09:33 AM   #105
John D
Senior Member
John D's Avatar
Join Date: 02-01-08
Location: Rockford, MI
Posts: 797
iTrader: (6)
Mentioned: 1 Post(s)

Originally Posted by whiterhino View Post
Interesting. I picked up my oil pressure right at the back of the block above the bell housing.
It was questioned if it was needed or not a few posts ago; so did you run both the stock sender and the aftermarket or just the aftermarket?

Originally Posted by Haggar View Post
Here's the pics of doing the oil pressure sender. First drilling it out. Its wierdly angled, so you need to fixture it to be angled in 2 different planes. I screwed it to a piece of wood to help hold it. Set your drill stop to not go too deep.
Thanks for the pics on how you drilled this out.
John D is offline   Reply With Quote
Page generated in 0.10766 seconds with 22 queries