Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Good Place to get spindle/hub assembly
View Single Post
Old December 15th, 2005, 12:49 AM   #11
"The Situation"
Mclovin's Avatar
Join Date: 11-07-05
Location: Westland, Mi
Posts: 14,415
iTrader: (15)
Mentioned: 0 Post(s)
Send a message via AIM to Mclovin Send a message via Yahoo to Mclovin

Originally Posted by jeepfreak81
For the hinge. You never heard of this before? Use a spindle/hub assy with the area the studs normally are torched off and ground down. Weld the 2x2 to that and the spindle to the bumper you have your swingout tire carrier. Cheaper then buying a pre-done hinge online normally
Ok i didnt understand what u were talkin about.... U should've posted in your original post that u were inquiring about the hinge..
and and Hoser dont u have some freebie Buggy to go play with
Mclovin is offline   Reply With Quote
Page generated in 0.16442 seconds with 22 queries