Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - converting flatbed into tilt trailer
View Single Post
Old March 11th, 2011, 12:00 AM   #13
muddbogger98
Newbie
 
Join Date: 02-26-11
Location: Ypsilanti,MI
Posts: 12
iTrader: (0)
Mentioned: 0 Post(s)
Default

DO NOT use hinges from a home improvement store they can't hold the load.

Make the hinges. a u-shaped piece of steel (1/4" thick) with at least 1/2" grade 8 bolts (12,000 lb. clamp load). A-frame tounge right, remove it (make sure not to damage it), align the "hangers" with the tounge ( at the end furthest from the hitch), weld them on the fame of the trailer drill holes through the ends of the toung and hangers. Run a bar across the a frame at the front edge of the deck and put a hanger across the deck of the trailer over the bar, dril holes install hitch pin. Then you have a tilting trailer.

tipping is gonna depend on the trailer (I have one that as soon as you pull the pin on the unloaded trailer it tips on its own).

Last edited by muddbogger98; March 11th, 2011 at 12:07 AM.
muddbogger98 is offline   Reply With Quote
 
Page generated in 0.06604 seconds with 20 queries