Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Plasma Cutter Advice
View Single Post
Old March 10th, 2011, 05:28 PM   #9
Join Date: 03-10-11
Location: Saginaw, MI
Posts: 22
iTrader: (2)
Mentioned: 0 Post(s)

I'm late to the party, but for the sake of information...

I have one of these cutters, and as mentioned above, they aren't for heavy duty fab by any means. I got it for mainly bodywork and light duty stuff otherwise. It cuts sheet like butter, and doesn't argue with 1/8", but any thicker and you have to go slower, and be mindful of the duty cycle.

It gets the job done for me though, so I have no complaints... not to mention the local TSC accepted a 20% off HF coupon on top of the $699 sale price :)
collinskl1 is offline   Reply With Quote
Page generated in 0.15031 seconds with 22 queries