Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Good Place to get spindle/hub assembly
View Single Post
Old December 14th, 2005, 02:35 PM   #4
jeepfreak81
81 inches of fun
 
jeepfreak81's Avatar
 
Join Date: 11-10-05
Location: Lennon, Mi
Posts: 12,234
iTrader: (22)
Mentioned: 0 Post(s)
Send a message via AIM to jeepfreak81 Send a message via MSN to jeepfreak81 Send a message via Yahoo to jeepfreak81
Default

For the hinge. You never heard of this before? Use a spindle/hub assy with the area the studs normally are torched off and ground down. Weld the 2x2 to that and the spindle to the bumper you have your swingout tire carrier. Cheaper then buying a pre-done hinge online normally
jeepfreak81 is offline   Reply With Quote
 
Page generated in 0.04418 seconds with 20 queries