Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 1350e wont engage 4low
View Single Post
Old January 28th, 2011, 11:53 PM   #6
Brian R.
deathbypsi's Avatar
Join Date: 08-08-07
Location: Temperance Mi
Posts: 2,027
iTrader: (16)
Mentioned: 0 Post(s)
Send a message via AIM to deathbypsi

All good now! In the grey plug under the overflow tank is the red/white wire that use to run to the NSS on the a4ld. I just removed that pin from the plug and grounded it to the fender and now it goes right into 4low.

I also discovered I forgot to plug the VSS back in when I put the T-case in.Not sure if this was affecting anything or not but its plugged in now.
deathbypsi is offline   Reply With Quote
Page generated in 0.12380 seconds with 22 queries