Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Early Bronco tie rod flip
View Single Post
Old January 5th, 2011, 06:46 PM   #9
84mudder
Senior Member
 
84mudder's Avatar
 
Join Date: 07-22-09
Location: Waterford MI
Posts: 1,032
iTrader: (16)
Mentioned: 0 Post(s)
Send a message via AIM to 84mudder
Default

Quote:
Originally Posted by CheapThrillB2 View Post
There is not an insert you can just simply install to flip the tie rods on the knuckles. You have to drill or ream the top side first.
i heard after reaming the knuckles from the top down requires a special nut insert to allow the TRE to fit perfectly in the hole.
84mudder is offline   Reply With Quote
 
Page generated in 0.04918 seconds with 20 queries