Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Kyle M. Ranger Truggy, rebuilt again - Revision 4
View Single Post
Old January 5th, 2011, 11:30 AM   #168
Kyle M.
MetroFab Customs
Kyle M.'s Avatar
Join Date: 10-24-10
Location: Sand Lake, MI
Posts: 9,443
iTrader: (20)
Mentioned: 71 Post(s)

Originally Posted by CheapThrillB2 View Post
You can take the full width and cut 6"s off the pass side to match an eb. You can reuse the carrier regardless of hp or lp. I think the drivers side inner is .5" shorter on the inner.
The driver side is shorter on which one?

So if I leave it full width, I only need to get another passender side chromo shaft? I can use the drivers EB shaft?
Kyle M. is offline   Reply With Quote
Page generated in 0.10752 seconds with 22 queries