Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - "Dirthead 509" TJ Project
View Single Post
Old January 2nd, 2011, 08:16 PM   #399
feva4u's Avatar
Join Date: 04-01-07
Location: Caledonia, MI
Posts: 10,604
iTrader: (12)
Mentioned: 11 Post(s)

Turned down my helper sliders to 1/2" thickness which took care of the problem with the helper springs blocking out.

Sits alot closer to where I thought it would now. I'm just going to run what I have for now and adjust the slider stop once I get the limit straps installed.
I ordered limit straps, rear pinion guard and steering heims from Ruffstuff last week. Back does more work than the front, I took a picture when measuring for limit straps thursday.

I also installed my hood pins, reassembled and installed my coilovers and got to play with the bender for the first time. A little narrower than I wanted but it's not terrible. Full bump in the front(coilovers were out at the time).

Still trying to figure out what I'm going to do for fenders. I need to go past where highlines normally cut, not sure on how that's all going to work yet.
My Jeep
feva4u is offline   Reply With Quote
Page generated in 0.06541 seconds with 21 queries