Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Ball Joints. 96 2500 4x4. How hard & what to get?
View Single Post
Old January 1st, 2011, 11:54 AM   #1
Tie Dyed
O.G.
 
Tie Dyed's Avatar
 
Join Date: 11-04-05
Location: Howell
Posts: 4,201
iTrader: (28)
Mentioned: 0 Post(s)
Send a message via AIM to Tie Dyed
Default Ball Joints. 96 2500 4x4. How hard & what to get?

So, on my jeep, I would run the autozone ones just because they always had them in stock. However, for my truck I want something a little better. I am looking to put a plow on the front of it next year.

What do you guys run? Do I need a special tool to pull the axle shaft? I have done ball joints on the jeeps. and it was pretty straight forward, is it the same on the trucks?

Truck is a 96 2500 4x4 with the V10 Dana 60.


Thanks for your input!!
__________________
2000 XJ with a 3 inch body lift
Tie Dyed is offline   Reply With Quote
 
Page generated in 0.06037 seconds with 20 queries