Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - ZJ bumper build
Thread: ZJ bumper build
View Single Post
Old December 29th, 2010, 11:56 PM   #12
Redneck Excavator
Spudy's Avatar
Join Date: 05-13-07
Location: Lakeview 48850
Posts: 1,255
iTrader: (13)
Mentioned: 0 Post(s)

i ended up having to notch it to make it fit into the unibody rail. There was a diple die spot in there on one side and the 2x4 steel would not fit past it if i remember right. Pic added

Also made it easier to weld the nuts on to bolt through.
Spudy is offline   Reply With Quote
Page generated in 0.18274 seconds with 22 queries