Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Mid-Engine Sand rail Project
View Single Post
Old December 23rd, 2010, 10:55 PM   #22
Christmas Cookie
rack tap re-rack click
Christmas Cookie's Avatar
Join Date: 07-10-07
Location: Genesee County
Posts: 13,504
iTrader: (40)
Mentioned: 8 Post(s)

Originally Posted by garemo View Post
oh ok im gonna use a type 002 that i had on my rail for my baja project but i was told im gonna have to do some fabrication to make it fit
3rib or 5rib...both of which are considered 002 trans...they are not that hard to set up in a car

Originally Posted by Drewman79 View Post
Thanks for the info guys! heres pics of the trans...
std trans with an hd side cover. if you dont drive like an asshole it will hold up just fine...start getting heavy with that clutch and you wont like the outcome

Originally Posted by Sandster View Post
It looks like a car trans. i know that the 6 and 3 rib bus trans are suppose to be stronger but you would have to do a lot of things to make it fit. i just bought a berrian chassis with a 1641 VW engine that is a ton of fun haven't had it in the dunes yet but went trail riding a couple times it was a blast.
the biggest thing to use a bus trans is the cv flanges...most people convert to 930 cv's and call it a day
Christmas Cookie is offline   Reply With Quote
Page generated in 0.17620 seconds with 22 queries