Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - help tube frame design
View Single Post
Old September 12th, 2006, 09:04 PM   #12
VonDirt
Senior Member
 
VonDirt's Avatar
 
Join Date: 08-10-06
Location: west side michigan
Posts: 629
iTrader: (19)
Mentioned: 0 Post(s)
Default

[QUOTE]I have bent up nearly 30 cages, even exos, and I could barely get the steel for what a good chassis goes for, not to mention all the time and headaches of designing it.[/QUOTE]

yea what cooter said X10 -

i buy reasonable quantities of material and have decent stuff to work with but i cant touch their cost. its tuff to beat buying something and then going to town on it, saves time and money all around plus alot of the geometry is sorted out or at least at a good starting point.
VonDirt is offline   Reply With Quote
 
Page generated in 0.05933 seconds with 20 queries