Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - First ATV; 1989 Polaris 4x6 Big Boss
View Single Post
Old December 17th, 2010, 08:52 PM   #5
baja74vw
Newbie
 
Join Date: 12-17-10
Location: Montana
Posts: 2
iTrader: (0)
Mentioned: 0 Post(s)
Default

Just bought the same Polaris. It is factory with 6 wheels. Not shaft driven, chain from the engine to middle wheels, different chain from the middle to last set of wheels. Great advice from the other people.

Carb clean, adjust chain tension, check all bushings, brake pads. Lots of people remove the oil pump and mix their own. This is because the pump goes out and the motor burns up. A lot cheaper to mix your own.

Hope the project works out. if you see this and need any other help, PM me.

Tim


__________________________________________________ _______________

www.goldplug.com
baja74vw is offline   Reply With Quote
 
Page generated in 0.05654 seconds with 20 queries