Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Plasma Cutter Advice
View Single Post
Old December 4th, 2010, 11:09 AM   #8
Senior Member
knaffie's Avatar
Join Date: 01-13-08
Location: home is where I hang my hat
Posts: 2,023
iTrader: (11)
Mentioned: 3 Post(s)

Originally Posted by fflinstone View Post
When it comes to plasma cutters there is one brand HYPERTHERM and then there is all the rest. (not that the rest are bad, but they are not hypertherm) if you cant afford a decent compressor, then you cant afford a plasma cutter. I am not trying to be a dick but thus is a tool you do not want to do cheap!
I was going to write the the exact same thing. I've used every brand out there and I have no idea why the Hypertherms are so much better than the rest, but they absolutely are.
knaffie is offline   Reply With Quote
Page generated in 0.09977 seconds with 22 queries