Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Plasma Cutter Advice
View Single Post
Old November 23rd, 2010, 09:19 PM   #1
Impact
Member
 
Join Date: 02-16-10
Location: Canada
Posts: 46
iTrader: (0)
Mentioned: 0 Post(s)
Default Plasma Cutter Advice

Hey Guys,

I'm wondering if anybody has any experience with this plasma cutter?

http://www.hobartwelders.com/product...50ci/#Features

I have been looking for a plasma cutter for a little while now but my only concern with getting one was that I required a compressor.
This plasma cutter has a built in compressor and runs off of a standard house hold plug in. I figure this would be good for using to make brackets and cutting body panels instead of using a grinder with cut off wheel
This cutter is currently on sale for $699...

Any advice would be greatly be appreciated!
Impact is offline   Reply With Quote
 
Page generated in 0.05902 seconds with 20 queries