Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - How to: Tj/Xj/Yj 30 with 44 knuckles
View Single Post
Old November 13th, 2010, 08:20 AM   #41
Senior Member
RAVC1's Avatar
Join Date: 05-24-06
Location: Brighton, MI
Posts: 142
iTrader: (4)
Mentioned: 1 Post(s)
Default Re: Tj/Xj/Yj D30 w/D44 Knuckles

This is good information; particularly regarding the axle width. In fact, with the slight increase of your hybrid D30 above the OE Xj D30 it makes me wonder if it is possible to cut off some of the inner spline to get the desired inner shaft length. I realize this may be a naive or even dumb question but I had to has been two years since I had my Xj HP D30 apart so those images are long gone from my memory. I will check Billavista's article regarding the custom length inner shafts.

Are you able to break down the vehicle models, model years and components I would need to make a complete HP D30 for my Xj's? Forgive the question but I have no idea. The Cj D30 housing is fairly easy to understand but I would rather ask and know before I begin buying hardware. I need a little more specific information that what you provided to know what vehicles/model years/axles to pursue.

I found this after posting my reply:

Last edited by RAVC1; November 13th, 2010 at 10:08 AM. Reason: Found a useful D44 reference
RAVC1 is offline   Reply With Quote
Page generated in 0.16359 seconds with 22 queries