Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 1994 ford ranger not starting
View Single Post
Old October 19th, 2010, 07:31 PM   #4
Go until it breaks.
JohnL's Avatar
Join Date: 02-20-09
Location: Greenwood , Indiana
Posts: 2,101
iTrader: (8)
Mentioned: 0 Post(s)
Send a message via AIM to JohnL

Could not find a bad vacuum or any unhooked wires. Had voltage at the coil pack and replaced it just to be sure it was good.

I checked the check engine light since it is OBDI and it brought back the 3 digit code 5-2-2 which is Park/Neutral Position (PNP) or Clutch Pedal Position (CPP) circuit fault - PNP
transmission MLP sensor out of range in park - Transmissions.

It is a manual so it not reading the clutch would make it not start.

Anyone have any experience with this issue ? How to fix it ?

JohnL is offline   Reply With Quote
Page generated in 0.14431 seconds with 22 queries