Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 1994 ford ranger not starting
View Single Post
Old October 16th, 2010, 07:07 AM   #3
chris1044
Senior Member
 
chris1044's Avatar
 
Join Date: 11-05-05
Location: Lost in the mitten!
Posts: 2,012
iTrader: (4)
Mentioned: 0 Post(s)
Default

coil pack plugged in over passenger valve cover?

Check for spark at one of the cylinders...if you've got it, make sure the wires are routed from the correct coil pack positon to the correct cylinder.

The upper intake has to come off to do the VC's on this motor - are all the vacuum lines correctly hooked up to the rear of it?

MAF sensor plugged in?? Air intake was likely removed...

Possible vacuum leak at upper intake gasket...


Those are about the only things I can think of going wrong when you do this job....
chris1044 is offline   Reply With Quote
 
Page generated in 0.05133 seconds with 20 queries