Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - sterling 10.5 front axle, Now a Build Thread!
View Single Post
Old September 23rd, 2010, 11:12 PM   #54
Jrod-13
poser wheeler
 
Join Date: 08-31-06
Location: Tower, MN
Posts: 78
iTrader: (0)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by keithshotrodshop View Post
Nobody has mentioned yet that the 35 splines are not the same. I figured this out when I tried swapping sterling for dana 70 shafts. They are both 1.5 inch 35 spline, but they are cut at a different angle, and will not slide into eachother. The sterling has wide cut steep splines while the 60/70 has narrow cut splines with less of an angle.


Interesting.. my buddy made a 609, using 50 knuckles, dana 60 shafts and a 9" center. He turned down sterling side gears, and put the in a 9" carrier to make a spool, and the 60 shafts slid right in..
Jrod-13 is offline   Reply With Quote
 
Page generated in 0.05622 seconds with 20 queries