Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - information on fixing a wagoneer
View Single Post
Old September 1st, 2006, 01:16 AM   #10
busyfixin
Balls Deep
 
busyfixin's Avatar
 
Join Date: 03-24-06
Location: williamsburg, MI
Posts: 3,309
iTrader: (11)
Mentioned: 1 Post(s)
Default

m715 windshield, with a full cage and canvas top, like the ones for scouts would be sweet. then cut the window frames off of the doors, remove the windows from the doors. cut a couple pieces of .5" o.d./.375" id pipe about 1.5 inches long. weld them in the slot where the windows used to be. build window frame work out of .375" round stock. make the bottom piece like this: ;--_______--; the ; parts would slide into the pieces of pipe. then go forward to the windshield frame, up the frame, back to the rear of the door, and back down to the bottom piece. then make canvas covers, with windows. have an extra flap with snaps that snaps on about one inch outside the window slot. repeat for the other 3 doors, and the gate window. then you would have two piece doors, allowing it to look right with the top down, and have half doors.

one question though. is it a two door, or 4 door?
busyfixin is offline   Reply With Quote
 
Page generated in 0.07490 seconds with 20 queries