Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Eastwood HotCoat Powdercoating session today
View Single Post
Old September 13th, 2010, 05:56 AM   #116
dale j
Senior Member
 
dale j's Avatar
 
Join Date: 03-27-10
Location: lansing, mi
Posts: 146
iTrader: (1)
Mentioned: 0 Post(s)
Default

sorry for double post but had to input on holes. as far as i recall nutseats should be free from coating and this was accomplished by a tapered nylon brush gently pushed into holes after coating and a chip brush was brushed across the hub surface eliminating any possible high spots from coating
this help make sure that there isnt any unexplained out of balance conditions
(sit flat against hub on vehicle) also prevents fitment problems due to most auto wheels being "hub centric" (centered by hub instead of lug nuts)
dale j is offline   Reply With Quote
 
Page generated in 0.05381 seconds with 20 queries