Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - s10 sas project
Thread: s10 sas project
View Single Post
Old September 12th, 2010, 08:48 PM   #12
Senior Member
spr_chicken's Avatar
Join Date: 05-12-08
Location: Grand Haven / Michigan
Posts: 1,124
iTrader: (9)
Mentioned: 0 Post(s)
Send a message via MSN to spr_chicken Send a message via Yahoo to spr_chicken

Originally Posted by vince43m View Post
yeah i will be ditching the bed down the road.. when i can make a tube flat bed type setup

i picked up my 89 waggy d44 front axle today.... sucker is fukin huge and weighs a shit load next will be my rear from a Isuzu factory disk breaks..... and 4.10 gears

then i belive iml be running full spools f/r chepp ant they get the job done
put in a mini spool save some money

Originally Posted by Mclovin View Post
you will regret going spool in the front
why? just unlock one hud on tight trails. its nice to have the traction when you need it. for a budget build run it.
spr_chicken is offline   Reply With Quote
Page generated in 0.11441 seconds with 22 queries