Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Eastwood HotCoat Powdercoating session today
View Single Post
Old September 12th, 2010, 06:47 PM   #113
Terminator 2
amundaza's Avatar
Join Date: 07-24-07
Location: Rochester Hills, MI
Posts: 1,158
iTrader: (23)
Mentioned: 0 Post(s)

Originally Posted by dale j View Post
hey i used to work for an aluminum wheel manufacturer. when the wheels were being painted they were hung from a hook -2 at a time- that contacted two spots on the inside (brake side for those who dont follow) and a hook near the bead seat.
Dale, thanks for the input, I think I follow you and see it somewhat in the pics you sent me in the follow up post. Once I get a welder, I'll most likely fab some up to see how they work.

I have also heard of guys setting the rims on really LARGE metal funnels, turned upside down, so that center hole of the wheel, rests on the cone of the funnel. This would lay them flat in the oven.
amundaza is offline   Reply With Quote
Page generated in 0.15997 seconds with 22 queries