Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Axle Part(s): 14 bolt/Dana 60 and 5 on 5.5 parts
Thread: Axle Part(s): 14 bolt/Dana 60 and 5 on 5.5 parts
View Single Post
Old September 9th, 2010, 08:21 AM   #1
Jsawduste
Senior Member
 
Jsawduste's Avatar
 
Join Date: 08-02-06
Location: New Baltimore
Posts: 662
iTrader: (15)
Mentioned: 1 Post(s)
Default 14 bolt/Dana 60 and 5 on 5.5 parts

All brand new unless stated !!

Some is 5 on 5.5 others are generic.

NIB Ballistic 14 bolt shave kit $215.00

Turned 14 bolt 5.13 gear set for the Ballistic shave kit Brand NEW. Ballistic says to turn it to 10.062 max.. I went to 10.058 for a little more room. $275.00

Detroit Locker NEW in the box $400.00

4.10 down carrier. I`ll add it to the locker if you want to pay shipping OR $25.00

14 Bolt housing bare $35.00

14 bolt 1410 yoke with U-bolts. From Jess at HAD $100.00

Hubs (C&C flavor) machined for 5 on 5.5. Done the RIGHT way. Complete with brand new rotors 9/16th`s studs. $250.00
http://www.pirate4x4.com/forum/showt...191&highlight= Pending sale

Have the matching shafts with the turned down flange. $50.00

Dana 60 Super 60 housing. 3 ½ inch tubes. Short side retubed. Drivers drop but could be used in a rear or maybe a passenger drop.$200.00

Dana 60 Chevy flavor knuckles. 3 of them. One is brand new never used. $150 for the pair. $50 for the loner

Solid 5 on 5.5 Dana 60 hubs. With NEW rotors and 9/16th studs. Turned after assembly. This are straight with no runout. NEW $400.00

Caliper (Solid) brackets to run the 5 on 5.5 wheels in a Dana 60 $75.00

Pair of new spindles Dana 60 Chevy flavor $150.00

35 spline stubs Again NEW 10 Factory brand. Chevy/Dodge length $200.00

Shipping from 48047 or pickup can be arranged
Jsawduste is offline   Reply With Quote
 
Page generated in 0.05186 seconds with 20 queries