Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 4.88 gears ... cost?
View Single Post
Old September 7th, 2010, 10:26 PM   #10
Senior Member
wally431's Avatar
Join Date: 09-22-09
Location: frankfort
Posts: 937
iTrader: (17)
Mentioned: 0 Post(s)

Originally Posted by dougstephvoor View Post
reading your post as I am trying to figure out if I can push 35's with my 4.0L and 4-11's.

And have one bit of input. I have a rubicon with a tere flex 3-1/2" lift. I have 285's that are 33 tall and 10-5 wide, and in a full stuff I will get rubbing on any corner. So what I am getting at is a 2 inch lift will not get 33 12-5's with out significant rubbing.
I call bull shit, i ran 33s with 2in coil spacers. I did put tube fenders in the front but i only had minimal rubbing.
wally431 is offline   Reply With Quote
Page generated in 0.15995 seconds with 22 queries