Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 4.88 gears ... cost?
View Single Post
Old September 7th, 2010, 08:34 PM   #8
HVYRTFT
Reed my teef
 
HVYRTFT's Avatar
 
Join Date: 01-17-07
Location: Whitehall,MI
Posts: 2,436
iTrader: (9)
Mentioned: 1 Post(s)
Default

Quote:
Originally Posted by keithshotrodshop View Post
if you are doing it yourself, save the money and don't buy an install kit. 95 percent of the re-gears i've done i've been able to re-use bearings/seals/shims. You may need to pick up extra shims, which aren't much, or someone might even toss you some from an old project. Crush sleeves are cheap enough, but sometimes you can re-use them as well if there's enough left in them.

Just inspect bearings, races, and such. You'll often find everything in good shape, if not, it's much cheaper to replace just the needed parts than to buy everything you don't need in a kit.
x2
HVYRTFT is offline   Reply With Quote
 
Page generated in 0.05076 seconds with 20 queries