Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 4.88 gears ... cost?
View Single Post
Old September 7th, 2010, 08:33 PM   #7
kkodet
Senior Member
 
kkodet's Avatar
 
Join Date: 01-21-07
Location: Marine City, Michigan
Posts: 4,733
iTrader: (47)
Mentioned: 5 Post(s)
Default

If you are doing it yourself, save the money and don't buy an install kit. 95 percent of the re-gears I've done I've been able to re-use bearings/seals/shims. You may need to pick up extra shims, which aren't much, or someone might even toss you some from an old project. Crush sleeves are cheap enough, but sometimes you can re-use them as well if there's enough left in them.

Just inspect bearings, races, and such. You'll often find everything in good shape, if not, it's much cheaper to replace just the needed parts than to buy everything you don't need in a kit.
kkodet is online now   Reply With Quote
 
Page generated in 0.06219 seconds with 21 queries