Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - The Beast (My Little ZUK Build)
View Single Post
Old September 5th, 2010, 03:12 PM   #64
Senior Member
Jdc215's Avatar
Join Date: 02-18-08
Location: Hartland/Fenton
Posts: 1,073
iTrader: (6)
Mentioned: 0 Post(s)

i have begun to dig a little deeper into locker problem, after further examination i think either i have a bad front output shaft or the front axle housing is bent. i'm going to try to check the front output tomorrow since i don't have work. the transfer case i swapped in has the early style front output and the one i took out has the later style so i'm going to swap that first. if it doesn't fix the problem at least ill have the better shaft installed.
Jdc215 is offline   Reply With Quote
Page generated in 0.13246 seconds with 22 queries