Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Waggy dana 44 dis/assembly axle shaft/gears breakdown steps, with photos.
View Single Post
Old August 29th, 2010, 01:22 PM   #10
whiterhino
I'm not old, honest...
 
whiterhino's Avatar
 
Join Date: 03-07-06
Location: Davisburg MI
Posts: 22,329
iTrader: (22)
Mentioned: 27 Post(s)
Default

Quote:
Originally Posted by Carbon View Post
I can not remove the free floating lockout. I removed the outer ring and the center ring. It will not move. I can move the shaft itself in and out a bit but the lock out will not move. Whats the trick?
Quote:
Originally Posted by sodapop View Post
You have the big outer wire ring out? and the snap ring off? If you do then that's all there is to do. Is you fuse broke and binding things up?
It sounds like he may have removed the wire and snap rings. Just guessing here.

Carbon, you need to be a bit more specific. Are both rings removed? Next, take a couple of the long bolts that held the lockout in place and screw them into the inner lockout splined ring. Put them 180* across from each other. This is what's shown in the 4th pic above.
whiterhino is offline   Reply With Quote
 
Page generated in 0.06313 seconds with 20 queries