Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Layout / Setup / Fixture / Tslot Table - 4' x 8' x 6" Thick on stand
View Single Post
Old August 15th, 2010, 06:44 PM   #1
lt1yj
Senior Member
 
Join Date: 01-04-06
Location: Holland, Mi
Posts: 1,201
iTrader: (14)
Mentioned: 0 Post(s)
Default Layout / Setup / Fixture / Tslot Table - 4' x 8' x 6" Thick on stand

I have what I call a layout or setup table with 3 T slots in it. It is 4'x8' and is about 6" thick hollow cast iron with webbing underneath. It was ground when new and is still in very good condition. Two slots were milled it in at some time in it's previous life and there is at least one hole drilled and tapped in one corner. This could probably be used as a bed plate as well.

I bought it for a welding table but can't bring myself to ruin it.

The plate is on a support table with jack screws to level it putting it about 3' off the floor.

I'm guessing it weighs in the 2500-3000# range.

I'm asking $1200 for it and can load on your trailer. I can be talked into delivery for a fee if you live within 100 miles and can prove you have a safe way to remove it from my trailer.

If you know what this is and need one you know this is a screaming deal. If you don't know what this is then you probably don't need it anyway.

I will take pics on Tuesday and can email or upload them then.
lt1yj is offline   Reply With Quote
 
Page generated in 0.05556 seconds with 20 queries