View Single Post
Old August 9th, 2010, 07:04 PM   #103
jbsjunk
Cop Rated
 
jbsjunk's Avatar
 
Join Date: 03-01-08
Location: Almost Allendale Mi
Posts: 12,885
iTrader: (35)
Mentioned: 9 Post(s)
Default

I don't think there is going to be any issues. Things are a bit tight, but that can be worked around once I get around to building my exhaust. My current debate is either running a pipe down each side, or have a y-pipe by the engine on the pass side and run down the pass side only. The hole I have to work with on the drivers side don't leave alot of room for heat to move around and might cook the brake fluid and fuel line. I might get it on the hoist at work to do all my cut and paste one of these days.
jbsjunk is offline   Reply With Quote
 
Page generated in 0.04031 seconds with 11 queries