Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Project Cumdumpster
View Single Post
Old August 2nd, 2010, 08:19 PM   #117
mj23polaris
Senior Member
 
mj23polaris's Avatar
 
Join Date: 09-21-09
Location: Manitou beach
Posts: 233
iTrader: (0)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by RDK_YJ88 View Post
I believe it was only trussed between the Spring mounts. This caused it to bend between the knuckle and spring mount (Difficult area to truss?)
ok yea its only the driver side tube tearin out of the diff, yea i think makin a truss that goes outside the springs would mean the truss is on the bottom of the axle?
mj23polaris is offline   Reply With Quote
 
Page generated in 0.06193 seconds with 20 queries