View Single Post
Old July 29th, 2010, 03:39 AM   #2
bud_light_zero200
Senior Member
 
bud_light_zero200's Avatar
 
Join Date: 08-25-08
Location: lawrence Michigan
Posts: 139
iTrader: (0)
Mentioned: 0 Post(s)
Send a message via Yahoo to bud_light_zero200
Default

It's been done in a dakota with major mods, usually they choose a 3/4 - 1 ton chassis for this swap. I would say it's kinda like a big block swap. Standard crap applies.......make the exhaust fit, complete computer swap from the original truck, the engine harness, trans harness, gotta see if the fuel pump pressure can hold up? Maybe even a fuel tank swap, I don't know about the front suspension on a 1500........the weight shouldn't be too drastic from a v8 to a v10?, I bet that trans for the v10 is totally differ from the v8 one and has a HUGE cooler, fab some engine mounts or just buy them. I've seen guys swap in a turbo cummins deisel into a gas 4x4 truck was pretty bad ass. Would be a cool unique project. Good luck

Last edited by bud_light_zero200; July 29th, 2010 at 03:44 AM.
bud_light_zero200 is offline   Reply With Quote
 
Page generated in 0.04062 seconds with 11 queries