Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Why Four Wires on my trailer brakes?
View Single Post
Old June 30th, 2010, 07:15 PM   #2
Buy a Fiat! Save the UAW!
Yetti's Avatar
Join Date: 11-05-05
Location: 20 minutes south of Hell...
Posts: 14,395
iTrader: (10)
Mentioned: 2 Post(s)

I would assume the axle uses a ground? in the case of the backing plate the assembly would be a ground with power supplied to the magnet? so that being said they are probably static wires to prevent current draw through a bearing. if that were to happen they would arc even while turning and eat the bearing in a very short time.
Yetti is offline   Reply With Quote
Page generated in 0.05123 seconds with 21 queries