Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Weld on D-ring tabs *FOUND*
View Single Post
Old June 29th, 2010, 12:52 AM   #7
Motorcitydak
Merkin salesman
 
Motorcitydak's Avatar
 
Join Date: 10-20-06
Location: Casco, Mi
Posts: 1,247
iTrader: (6)
Mentioned: 0 Post(s)
Send a message via AIM to Motorcitydak
Default

You can always make your own if you have a few tools available (grinder and drill/drill press). I bought mine from some company, I forgot who. They are just 1x2 solid steel bar about 4 inches long. Just use a 1 inch hole saw for the ring hold and round off the ends. It will be a huge PITA cutting a 1 inch hole in them but it may be your best option
Motorcitydak is offline  
 
Page generated in 0.05370 seconds with 20 queries