Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Replacing spring bolts XJ Dana 35
View Single Post
Old June 12th, 2010, 01:33 PM   #7
Jeeperz Creeperz
GL 4x4 Vendors
 
Jeeperz Creeperz's Avatar
 
Join Date: 11-08-05
Location: Wyandotte, MI
Posts: 3,127
iTrader: (13)
Mentioned: 1 Post(s)
Send a message via ICQ to Jeeperz Creeperz Send a message via AIM to Jeeperz Creeperz Send a message via MSN to Jeeperz Creeperz Send a message via Yahoo to Jeeperz Creeperz
Default

Quote:
Originally Posted by GREASYHANDS View Post
looks like Muskegon brake is the only place around that carries then size that I need.

So now after looking at my front leaf eye bolts Im not to excited about puting this together. I have been told to cut into the uni-body but after looking over it I am confused. I dont want to cut the inner side do I? I think that I will need to cut just under the outer pocket that hold the bolt, any one else doing this? I would assume it needs to be reinforced once cut.
What they mean is cut a hole on the inside of the uniframe so that you can get to the nut side, which is captured inside the uniframe.

I myself prefer to cut the spring apart to save the bolt and the uniframe.
Jeeperz Creeperz is offline   Reply With Quote
 
Page generated in 0.69229 seconds with 20 queries