Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Are my gears Standard Cut (LP) or Reverse Cut (HP)?
View Single Post
Old June 6th, 2010, 12:11 AM   #24
PavementPounder
I am the law.
 
PavementPounder's Avatar
 
Join Date: 11-05-05
Location: Birmingham, Michigan 48009
Posts: 29,824
iTrader: (224)
Mentioned: 2 Post(s)
Default

Quote:
Originally Posted by pigfat View Post
picture this. The drive shaft spins in a clockwise motion. Now you take the axle off and flip it over. The driveshaft still turns in a clockwise motion. Hence the tire regardless of its position still rotates in the same direction.
I can see that nobody can help you understand this.

The issue isn't what direction the tire is turning. We all know that never changes. The issue is where the ground contacts it.

Go pick up a pencil. Seriously.
PavementPounder is offline   Reply With Quote
 
Page generated in 0.05694 seconds with 20 queries