Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - The Beast (My Little ZUK Build)
View Single Post
Old May 30th, 2010, 01:41 AM   #47
Jdc215
Senior Member
 
Jdc215's Avatar
 
Join Date: 02-18-08
Location: Hartland/Fenton
Posts: 1,071
iTrader: (6)
Mentioned: 0 Post(s)
Default

i took my dad to the mounds today. it was great. off-roading isnt really his thing but he had a lot of fun. i ran some of the rock courses and some pretty technical dirt trails and i just didnt have the torque, just reinforcing my decision to get a 4X t-case. i also blew up one of my rear wheel bearings, and i need to make some HD shackles for the rear. the factory ones are bent so i think ill just make some stock length ones and replace all the shackle bushings. making a two piece shackle with some 1/4" flat stock and a drill press should me more than adequate. i already have a set of stock axle shafts with good bearings, so when i get around to repairing the brake lines ill put on some sj410 backing plates and cut out my brake backing plates for quicker rear shaft swaps.

4X t-case
install T-case mounts
reinforce t-case mounting brackets and arm
make HD shackles
replace and reroute brake lines
weld on rear axle truss
replace drivers side axle shaft
replace passenger side mirror glass
get new wheels for mud tires

long list of little things...
Jdc215 is offline   Reply With Quote
 
Page generated in 0.06132 seconds with 20 queries