Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Deranged 3.0
Thread: Deranged 3.0
View Single Post
Old May 12th, 2010, 09:19 PM   #55
Big Block Ranger
bigblockford79's Avatar
Join Date: 05-11-08
Location: Hamilton, MI
Posts: 2,805
iTrader: (24)
Mentioned: 3 Post(s)

Originally Posted by CheapThrillB2 View Post
Then set your pinion flat and remeasure.
Will do tomorrow morning.

How did you route your panhard bar? The mounts for the panhard on my truck are the biggest reason that I can't get the truck lower to the ground. I want it to be as flat as ride height as possible, but the frame side bracket get really close to the diff housing and 3 link brackets.

Does anyone running Hydraulic steering have any input on panhard bar set-up?? Everything I have found in searching says flat at RH for slwoer moving vehicles.
If you can read this, thank a teacher. If you can read it while pooping, thank Bill Gates!

"A girls butt hole is like a 9 volt battery. You know its wrong, but eventually you put your tongue on it."
bigblockford79 is offline   Reply With Quote
Page generated in 0.17202 seconds with 22 queries