Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Deranged 3.0
Thread: Deranged 3.0
View Single Post
Old May 11th, 2010, 06:30 PM   #49
Big Block Ranger
bigblockford79's Avatar
Join Date: 05-11-08
Location: Hamilton, MI
Posts: 2,805
iTrader: (24)
Mentioned: 3 Post(s)

Originally Posted by Jeepaholic View Post
Looks like you need to either rotate the inner c's or reduce your pinion angle.
Originally Posted by CheapThrillB2 View Post
Your caster is WAY to negative. Everything else looks great
The pictures are a little deceiving, the factory leaf mount is only about 2 degrees down in the front right now. Also, the pinion angle has not been set yet, it is only as good a guess as I could get by eyeballing it with a driveshaft that is 12" too short. I am certain that the pinion needs to be rolled down quite a bit yet. I will know for sure when I get the front shaft built in a week or two.
If you can read this, thank a teacher. If you can read it while pooping, thank Bill Gates!

"A girls butt hole is like a 9 volt battery. You know its wrong, but eventually you put your tongue on it."
bigblockford79 is offline   Reply With Quote
Page generated in 0.18823 seconds with 22 queries