Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - New CJ wiring harness (GM TBI conversion) SOLD SOLD SOLD
View Single Post
Old April 14th, 2010, 08:40 PM   #1
itchy
Senior Member
 
itchy's Avatar
 
Join Date: 09-11-06
Location: Brownstown, MI. 48174
Posts: 2,882
iTrader: (44)
Mentioned: 0 Post(s)
Default New CJ wiring harness (GM TBI conversion) SOLD SOLD SOLD

This is a brand new harness that was purchased for a project that has been sold, and it has never been used.

It is a factory Jeep CJ replacemnet harness with the "GM Throttle Body Injection" conversion. This is the harness you need to replace your worn out harness full of butt-connectors, and shrink tubbing, if you are installing a fuel injected Chevy motor in your 76-86 CJ. All the wires are tagged in groups, but not every wire individually. Like ignition switch, dimmer switch, headlight switch etc.... But I dont have the wiring diagram for the harness. But I found this one for a factory harness to go buy. Everything seems to match up very good.

http://www.iwantajeep.net/wp-content...g-diagrams.pdf

I'm asking $150.00 and I think that my price reflects the missing diagram. I payed closs to $300 for this when I bought it.

Thanks, Keith. 734 558 8998

Last edited by itchy; February 14th, 2012 at 10:04 PM.
itchy is offline  
 
Page generated in 0.05135 seconds with 20 queries