Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Checking for a good weld
View Single Post
Old April 13th, 2010, 10:22 PM   #10
lgottler
Senior Member
 
lgottler's Avatar
 
Join Date: 11-30-06
Location: New Baltimore, MI
Posts: 1,383
iTrader: (17)
Mentioned: 2 Post(s)
Default

I did a destructive test, I clamped it in a vice and bent it all the hell and back trying to rip it off

If I find one that has any defects, I'll try to get a cross section to see penetration.

I need a good check for the guy pushing the buttons. When its welding a new one, the operator is removing any spatter, verifying positions, and then finally checking weld quality on the last one.
lgottler is offline   Reply With Quote
 
Page generated in 0.04572 seconds with 20 queries