Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Checking for a good weld
View Single Post
Old April 9th, 2010, 09:07 PM   #2
chadcooper55
expert jeep disassembler
 
chadcooper55's Avatar
 
Join Date: 08-28-08
Location: kent city mi
Posts: 8,055
iTrader: (20)
Mentioned: 12 Post(s)
Default

The main thing you need to look at for what you are doing is the edge of the weld where it meets the metal. You are looking for cold roll. If it is tied in nice and sharp you should be good if you can see a small lip where it isn't tied in properly chances are it isn't. Also is your metal nice and clean where you are welding?
chadcooper55 is offline   Reply With Quote
 
Page generated in 0.04658 seconds with 20 queries