Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - SOLD - Off-Road Trailer Project
View Single Post
Old April 3rd, 2010, 10:35 PM   #1
computeruser
Senior Member
 
computeruser's Avatar
 
Join Date: 03-31-08
Location: East Lansing, MI
Posts: 392
iTrader: (10)
Mentioned: 0 Post(s)
Default SOLD - Off-Road Trailer Project



Sturdy chassis - 2x2x.25" square tube frame, .25" angle crossmembers, 2x2x.25" fabricated axle w/ 3500lb hubs, leaf springs w/ shocks, removable tongue with lunnette ring, lights, rear 2" receiver, spare tire holder, and body structure out of 1/8" angle. 3x 31-10.50 BFG AT tires on Jeep Canyon rims, bored out to clear the hub. Bulldog tongue jack.

Trailer body, with the tongue removed, fits in my 5x8' utility trailer.

Frame was welded with 220 MIG by a competent welder. Body structure was welded with 110 flux core by me.

Body structure partially completed:


Chassis structure, less body:


Underside, before shocks were added. Shocks do not hang down below axle or interfere with clearance.


Located in East Lansing. SOLD.

Last edited by computeruser; April 10th, 2010 at 09:21 PM.
computeruser is offline  
 
Page generated in 0.06340 seconds with 20 queries