Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - ZJ bumper build
Thread: ZJ bumper build
View Single Post
Old February 14th, 2010, 06:16 PM   #1
Spudy
Redneck Excavator
 
Spudy's Avatar
 
Join Date: 05-13-07
Location: Lakeview 48850
Posts: 1,205
iTrader: (13)
Mentioned: 0 Post(s)
Send a message via AIM to Spudy Send a message via MSN to Spudy Send a message via Yahoo to Spudy
Default ZJ bumper build

Hey all
I started working on a winch bumper for my zj today. Did not get a lot done but only had so much time with it being valentines and all. I started off and had to open up the front of the unibody so i could get in there. I decided to use a piece of 2x4 .25 wall tubing to do the main mounts. I had to cut out part of it so i could weld nuts on the inside. I also had to knock out a frame nut that was in the way. got all the holes drilled today and most are lined up good enough. Going to weld some nuts on it tomorrow or whenever i can steal the jeep back from the misses. (she drives it in the winter to work)







Spudy is online now   Reply With Quote
 
Page generated in 0.06483 seconds with 21 queries