Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - sterling 10.5 front axle, Now a Build Thread!
View Single Post
Old January 19th, 2010, 08:54 PM   #40
Mall Rated
TJontherox's Avatar
Join Date: 06-14-06
Location: Sterling Hgts, MI
Posts: 1,492
iTrader: (8)
Mentioned: 1 Post(s)
Send a message via Yahoo to TJontherox

Originally Posted by Jeepaholic View Post
cut off most of the tube, figure out method of removing plug welds, cut a slit in the tube to remove the pressure and hammer out the piece of tube. heat center and give it a go with your press to install the new tube.
My thoughts exactly. Would be cool to see this done
TJontherox is offline   Reply With Quote
Page generated in 0.05985 seconds with 21 queries