View Single Post
December 31st, 2009, 11:40 PM
Big Block Ranger
Join Date: 05-11-08
Location: Hamilton, MI
Mentioned: 3 Post(s)
Cab is now mounted
Cut the back section of frame off:
Welded on the new rear frame cap which will also be my mounting plate for the tube back-half.
The "wings" that extend out past the rails on the cap plate will be bent around and welded to the side of the frame rails for extra strength. I will also be boxing the frame and adding some extra inside gussets to make sure everything stays put.
If you can read this, thank a teacher. If you can read it while pooping, thank Bill Gates!
"A girls butt hole is like a 9 volt battery. You know its wrong, but eventually you put your tongue on it."
View Public Profile
Send a private message to bigblockford79
Find More Posts by bigblockford79
Page generated in