Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - "Cheapthrill-EB buggy verision" -not so cheap anymore pg 65
View Single Post
Old December 6th, 2009, 03:47 PM   #127
CheapThrillB2's Avatar
Join Date: 09-06-06
Location: Middleville, MI
Posts: 35,181
iTrader: (65)
Mentioned: 61 Post(s)

So was taking measurements today and if I pinch the front end I would have to move the core support closer to the engine. With the elec fan I plan to use this would only allow me to move the core support back only an inch before clearance with the water pump becomes an issue.

So I was thinking leaving the front width and just trimming the fenders, core support to allow for clearance.

CheapThrillB2 is offline   Reply With Quote
Page generated in 0.16899 seconds with 22 queries